Kubotek Forum

KeyCreator CAD & CKD Viewer Technical discussion of CAD/CAM and integrated partner products
Customer Forum > KeyCreator CAD & CKD Viewer > Auto Fit Zoom View modes: 
User avatar
Member
Member
dschell@pulsesystems.com - 1/10/2018 4:43:45 PM
   
Auto Fit Zoom
Anyone else having an issue where using Autofit zoom the entities are not centered in the viewport?. .035Ø X 8.00 LONG CYLINDER SOLID at X-0Y-0Z-0. Drawn in VIew 1. Auto Zoom and the crrcle is not centered in the viewport.

User avatar
Advanced member
Advanced member
michael@gutmandesign.com - 1/11/2018 9:25:23 AM
   
RE:Auto Fit Zoom
Greetings,

It is a strange anomoly.  If you increase the diameter to .25 it is still (slightly) off center.  If you leave the .035 diameter but shorten to a .001 disc then it centers!

If you explode the cylinder to a wireframe that is 8" long then does not center.  Circles -wireframe- center no matter what size.  Adjusting screen dimensions on  the tools panel has no effect.  Changing from Directx11 to open gl2 has no effect.

Try this:  draw an .001 circle at 0,0,0.  It autoscales fine.  Now move it in x direction 1000".  It autoscales centered but is no longer a circle!

Will refer this thread to tech support.  While I wouldn't lose sleep over it they should be made aware of this behavior.

All the best,
Mike





User avatar
Member
Member
jay.d.burkett@gmail.com - 1/24/2018 9:12:04 PM
   
RE:Auto Fit Zoom
Mike,

You are right.  The problem has apparently been there a while.  I tried it on V14.0.1 (3666) and I get the squiggly circle you desribe.  What's up with all of that?

Best regards,

Jay
Jay Burkett
Aerospace Engineer
Fairhope, AL

User avatar
Member
Member
MMozynski - 1/25/2018 10:07:55 AM
   
RE:Auto Fit Zoom
The graphics system is about half as precise as the data models. What you are seeing are little bits of drift because of the graphics card rounding off numbers.

1
Login