Kubotek Forum

KeyCreator CAD & CKD Viewer Technical discussion of CAD/CAM and integrated partner products

Customer Forum > KeyCreator CAD & CKD Viewer > Cylindrical Face Missing

View modes:

Valued member

evanags - 10/24/2017 11:55:24 AM

Cylindrical Face Missing

I have a spinneret ( die plate) with 32 3mm die holes drilled in a 10mm thick disc. When I drew it up a year ago, all was fine. Now I open the file and it looks the same except a part of the 3mm hole wall is just missing, you can see right thru. There are about 12 holes like that. Saving and re-saving does not correct it. It appears ok in wireframe mode, just not as a solid. Hopefully the file is not corrupt and can be repaired. What suggestions would anyone have for me to try?

Reply | Quote | Subscribe to post


Advanced member	francis.marcoux@ipexna.com - 10/24/2017 3:01:09 PM RE:Cylindrical Face Missing Hi, I've you tried to "rebuild wires" (Tools\maintenance)? Francis Marcoux KC 15.0 Reply \| Quote \| Subscribe to post

Valued member

evanags - 10/25/2017 11:00:07 AM

RE:Cylindrical Face Missing

I did look at that but did not try it. Just thought I would check here with the KC experts before I messed up my part. I did try rebuild wires and it worked. I guess my other question is why did it do it in the first place? I have opened and closed it a few times after finishing it a year ago, but just yesterday, again when I viewed it, it came in with the problem. Just curious how and why that happens. Perhaps a video card or a setting issue? Is this a typical scenario that other users run into a lot?

Thanks Francis for the prompt reply and answer.

Reply | Quote | Subscribe to post