Kubotek Forum

I find with the new version of KC that less lines are used to define or represent, say a tube or a sphere.

I find this makes it hard to work in wireframe render, which is often easier to work in since you can see "through" other parts. But because the shapes are less defined now, it is a lot harder to use. Unless there is a setting somewhere that I miss?

I have to often revert to section views now, which slows me down.

I modeled a swivel foot yesterday - the ball shows absolutely no outlines and I cannot even pick a center! In solid render it shows perfect, but again I cannot pick a center. File attached.

Anybode else with these problems?