Kubotek Forum

So I've been doing a lot of surfacing lately thus the need for creating spline and I would like to see some enhancements. I use blend spline as much as I can because it guarantees tangency but I have not ability to adjust the amount of tangency. I would like to be able to adjust the amount of tangency.

When creating splines I can adjust the tangency factor but I have to create the spline first and then if I dont like it I have to delete the spline adjust the factor and then create again
and rinse and repeat. The tangency factor should happen in real time, similar to the bridge command where I can see the curve change as I adjust the factor and then when I am happy I can hit done.

Modify Curve. If I am modifying a curve that has a tangency factor then that should not change while I adjust another control point. In fact I would like to see the tangency factor displayed in the Modify Curve dialog box and be able to adjust that value also using  Modify Curve .

If someone can give me some tip and tricks or if I am missing something please let me know.

thanks