Cliff
-
3/18/2020 11:16:32 AM
Automatic trim selection switch
I use "Trim Both" a lot, at least until recently. Is there a way to make it so I have to always select both entities (Previous method). It only selects the correct entity for me about half the time. It also seems to have an affinity for circles and arcs. So you know when it selects a circle or selects a parallel line, it fails, at least patially. I could see where it could save time, but my drawings are usually crowded enough it is a hindrance.
TIA
Cliff Asus G752 Laptop i7-6820K Win 10
|