Kubotek Forum

KeyCreator CAD & CKD Viewer Technical discussion of CAD/CAM and integrated partner products
Customer Forum > KeyCreator CAD & CKD Viewer > Rendering Problem View modes: 
User avatar
Advanced member
Advanced member
bert.fourie.nz@gmail.com - 12/26/2020 10:25:28 PM
   
Rendering Problem
I have a rendering issue that I am sure there must be a simple solution to: Say I draw a hollow tube and then place a flat bar on its edge lengthwise down the one side of the tube, and touching the insde wall - Then I get lines showing on the outside in the render view, but the internal plate does not touch the outside surface!
 How to fix please?

User avatar
Guest
jmccullough@kubotek3d.com - 12/28/2020 11:39:10 AM
   
RE:Rendering Problem
Bert, are you able to attach a picture? It's hard to understand the problem from the description. 
John Wright McCullough
GM Marketing, Kubotek3D

User avatar
Advanced member
Advanced member
wkrol@kubotek3d.com - 12/28/2020 4:40:58 PM
   
RE:Rendering Problem
It could be a facet issue.  Try a finer facet tolerance found under File> Properties. Move slider over 1 notch.

User avatar
Advanced member
Advanced member
bert.fourie.nz@gmail.com - 12/29/2020 5:13:34 PM
   
RE:Rendering Problem
It was the faceting tolerance. The object was a long dryer kiln and the size of it caused the issue. I do not normally have this problem. Once I increased the faceting tolerance to max the lines disappeared on close-up views, but from afar they still show. I think this is probably unavoidable and not really an issue.

I also exported the file for use in a FEA software and had no issues.

Some pictures attached.

1
Login